A3 Industries' limited bullpup kit skips the Stribog's 9mm, targets 10mm and .45
A3 Industries built a bullpup conversion for the Grand Power Stribog, but it only works on the 10mm and .45 ACP versions, not the 9mm that just won a world championship.
Snapshot
The Firearm Blog reports that A3 Industries' new kit swaps the factory lower on the Stribog SP10 and SP45 for a bullpup design, shrinking the carbine to 16 inches overall. The install takes about ten minutes, and only 100 kits exist at $999.95 each.
Key points
- Fit is limited: the kit works only on the Stribog SP10 (10mm) and SP45 (.45 ACP), not the 9mm SP9A3G that Pavol Zencar used to win the 2025 IPSC PCC/Mini Rifle World Shoot.
- Size and weight: the assembled gun runs 16 inches overall, with the lower alone at 2.5 lbs and about 6.5 lbs with the upper fitted, machined from 6061 aluminum in the USA.
- Fixed trigger setup: a pre-installed RAVE-140 trigger breaks at 3.5 lbs and is modified specifically for this conversion, so it's not swappable, alongside a Lingle Industries bolt catch and ambidextrous controls.
- Muzzle proximity warning: the source flags that the short bullpup layout puts the muzzle close to the support hand, which is why A3 includes a hand stop the outlet calls essentially mandatory.
- Legal note: since the lower isn't serialized, the kit ships as a non-firearm part, but installing it turns your Stribog into a short-barreled rifle, so buyers need to check local SBR rules first.
Quick take
Turning a Stribog into a bullpup is a strange move for a platform that just proved itself on the competition stage, but a 16-inch 10mm or .45 carbine is a genuinely different tool than a 9mm PCC built for speed. With only 100 units made and a trigger you can't change out, this reads more like a niche collector's piece than a mainstream upgrade.
Read the full story: thefirearmblog.com